Orion System PT-Link II BACnet3 - Manual (Page 10)

Zone
Zone
3. PT-LINK CONFIGURATION
PT-Link II BACnet3 Interface 10
4.) As shown in Figure 7, click <Properties> in the lower
left of the window. The Local Area Connection Properties
Window will appear.
5). As shown in Figure 8, in the Connection Items list box,
be sure the Internet Protocol (TCP/IP) is checked. Select the
Internet Protocol (TCP/IP) item to highlight it and then click
<Properties> . The Internet Protocol Properties Window will
appear.
3.3 IP Address Confi guration
3.3.1.1 Computer IP Address Set-up for
Windows NT & XP
1.) Click <start> ; then click <Control Panel> .
2.) Double-click on the Network Connections icon.
The Network Connections Window will appear (Figure 6).
NOTE:
If any wireless connections are listed, disable them
by right-clicking the connection and selecting
<Disable> .
3.) In the Network Connections Window, double-click the
Local Area Connections entry. The Local Area Connection
Status Window will appear (Figure 7).
Figure 6: Network Connections Window
Figure 7: Local Area Connection Status Window
Figure 8: Local Area Connection Properties Window
3.3.1 Computer IP Address Set-up for
Windows XP, Vista, 7 & 8
In order for the PT-Link II to communicate properly, it is imperative to
set the IP address of both the PT-Link II as well as the computer to be
within the same netmask. You need to change the IP address on your
computer. The following instructions will explain how to confi gure the IP
address for Microsoft
® Windows XP, Vista, 7, and 8 operating systems.