Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 116)

106 A PPENDIX C: M ANAGEMENT I NFORMATION B ASE (MIB) R EFERENCE
dsx1Loopback
Config { dsx1Config
Entry 9 } read-write “This variable represents
the loopback
configuration of the DS1
interface. Agents
supporting read/write
access should return
badValue in response to
a requested loopback
state that the interface
does not support. The
values mean:
dsx1NoLoop
Not in the loopback
state. A device that is not
capable of performing a
loopback on the interface
shall always return this
as it's value.
dsx1PayloadLoop
The received signal at
this interface is looped
through the device.
Typically the received
signal is looped back for
retransmission after it
has passed through the
device's framing
function.
dsx1LineLoop
The received signal at
this interface does not go
through the device
(minimum penetration)
but is looped back out.
dsx1OtherLoop
Loopbacks that are not
defined here.”
dsx1NoLoop(1) - the unit
does not have any loops
active.
dsx1PayloadLoop(2) - the
unit has a NET PLB
active.
dsx1LineLoop(3) - the unit
has a NET LLB active.
dsx1OtherLoop(4) - the
unit has a Port Loop
active. dsx1NoLoop(1) - the unit
will take down any active
loops.
dsx1PayloadLoop(2) - the
unit will initiate a NET
PLB.
dsx1LineLoop(3) - the unit
will initiate a NET LLB.
dsx1OtherLoop(4) - the
unit will initiate a Port
Loop on the first port.
Table C-3
Object Name Object ID User Access Object Description Get Set