Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 118)

108 A PPENDIX C: M ANAGEMENT I NFORMATION B ASE (MIB) R EFERENCE
dsx1Signal
Mode { dsx1Config
Entry 11 } read-write “‘none’ indicates that no
bits are reserved for
signalling on this
channel.
‘robbedBit’ indicates that
T1 Robbed Bit
Signalling is in use.
‘bitOriented’ indicates
that E1 Channel
Associated Signalling is
in use.
‘messageOriented’
indicates that Common
Channel Signalling is in
use either on channel 16
of an E1 link or channel
24 of a T1.”
none(1) - this signal mode
is the only mode
supported. No action, this parameter
may not be changed.
dsx1Transmit
ClockSource { dsx1Config
Entry 12 } read-write “The source of Tranmit
Clock.
‘loopTiming’ indicates
that the recovered
receive clock is used as
the transmit clock.
‘localTiming’ indicates
that a local clock source
is used.
‘throughTiming’
indicates that recovered
receive clock from
another interface is used
as the transmit clock.”
loopTiming(1) - the
Network Timing is set to
Network Clock.
localTiming(2) - the
Network Timing is set to
Internal Clock.
throughTiming(3) - the
Network Timing is set to
some other source than
Network or Interval. loopTiming(1) - the
Network Timing is set to
Network Clock.
localTiming(2) - the
Network Timing is set to
Internal Clock.
throughTiming(3) - the
Network Timing is set to
Port 2A Timing.
dsx1Fdl { dsx1Config
Entry 13 } read-write “This bitmap describes
the use of the facilities
data link, and is the sum
of the capabilities:
‘other’ indicates that a
protocol other than one
following is used.
‘dsx1Ansi-T1-403’ refers
to the FDL exchange
recommended by ANSI.
‘dsx1Att-54016’ refers to
ESF FDL exchanges.
‘dsx1Fdl-none’ indicates
that the device does not
use the FDL.”
Returns a sum of the
following
other(1) - Rem Comm
Channel is active.
dsx1Ansi-T1-403(2) - the
Network Framing is ESF,
and PRM Enable is
Enabled.
dsx1Att-54016(4) - the
Network Framing is ESF
or Rem Comm Channel is
active, therefore TR 54016
messaging is active.
dsx1Fdl-none(8) - the
Network Framing is D4,
and there is no active Rem
Comm Channel. No action, this parameter
may not be changed.
Table C-3
Object Name Object ID User Access Object Description Get Set