Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 3)

Notice to Users of 1.544 Mbps Service iii
Notice to Users
of 1.544 Mbps
Service
This equipment complies with Part 68 of the FCC rules. On the rear or bottom of this unit is a label that
contains the FCC registration number and other information. If requested, provide this information to
the telephone company. The following instructions are provided to ensure compliance with FCC Rules,
Part 68.
1 All direct connections to network lines must be made using standard plugs and jacks.
2 The following information may be required by the local telephone company when applying for leased
line facilities.
T1
FXO
E&M
3 If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until it is
learned whether the source of trouble is the equipment or the telephone line. If the equipment needs
repair, it should not be reconnected until it is repaired.
4 The unit has been designed to prevent harm to the network. If the telephone company finds that the
equipment is exceeding tolerable parameters, it can temporarily disconnect service. In this case, the
telephone company provides advance notice, if possible.
5 Under FCC rules, no customer is authorized to repair this equipment. This restriction applies
regardless of the warranty status.
6 If the telephone company alters its equipment in a manner that affect the use of this device, it must
provide warning so that the customer can arrange uninterrupted service. The customer will be advised
of the right to file a complaint with the FCC.
7 The attached affidavit must be completed by the installer.
8 In the event of equipment malfunction, all repairs should be performed by our company or an
authorized agent. It is the responsibility of users requiring service to report the need for service to our
company or to one of our authorized agents.
FXO only: The ringer equivalence number (REN) can be found on the front panel of the card. If
requested, provide this information to the telephone company. The REN is useful to determine the
quantity of devices that may be connected to the telephone line. Excessive RENs on the telephone line
may result in the devices not ringing in response to the incoming call. In most, but not all areas, the
sum of RENs of all devices should not exceed five (5). To be certain of the number of devices that may
be connected to a line, as determined by the total RENs, contact the local telephone company
Canadian
Emissions
Requirements
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital appara-
tus set out in the Radio Interference Regulations of the Canadian Department of Communications.
End users should use existing 48-VDC battery sources or a CSA-certified power supply.
Port ID SOC FIC USOC Jack
1.544 Mbps (SF)
1.544 Mbps (SF) (B8ZS)
1.544 Mbps (ESF)
1.544 Mbps (ESF)
(B8ZS) 6.0 N 04DU9- BN
04DU9- DN
04DU9- IKN
04DU9- ISN RJ- 48C
Port ID SOC FIC USOC Jack
2-Wire Loop Start
2-Wire Ground Start 9.0 N 02LS2
02GS-2 RJ-48M
Port ID SOC FIC USOC Jack
Type I E&M Interface
Type II E&M Interface TL31M or E
TL32M or E 9.0N RJ- 48M
✍