Delay seconds, Tx gain, Rx gain – Verilink PRISM 3030 (34-00208.L) Product Manual User Manual
Page 83: Channel allocation, Firmware revision
Configuration Screens
73
FXO.
FXO/LS:
Foreign Exchange Office/Loop Start
FXO/GS:
Foreign Exchange Office/Ground Start
FXO UVG:
Foreign Exchange Office/Universal Voice Grade
FXO UVGR:
Foreign Exchange Office/Universal Voice Grade
with Reverse Battery
DID/DNIS:
Direct Inward Dialing/ Dialed Number Identification Service
[Dial Pulse Terminate (DPT) mode]
4-Wire E&M.
F-3010-200--112
F-3010-200--114
Type I:
Signalling
Yes
Yes
Type II:
Signalling
Yes
Yes
Type III:
Signalling
Yes
Yes
Type IV:
Signalling
No
Yes
Type V:
Signalling
No
Yes
TO:
Transmission Only
Yes
Yes
Delay Seconds
If signalling mode has a delay, it can be set from 1 to 5 seconds.
Tx Gain
Selects the transmit gain over the following ranges:
2 -Wire FXS:
−
4.0 dB fixed
2 -Wire FXO:
−
6 dB to 0 dB
4 -Wire E&M:
−
14 dB to +2 dB
Rx Gain
Selects the receive gain over the following ranges:
2 -Wire FXS:
−
11 dB to 0 dB
2 -Wire FXO:
−
6 dB to 0 dB
4 -Wire E&M:
−
18 dB to
−
1 dB
Channel Allocation
Described in detail in Channel Allocation on page 63.
Firmware Revision
Identifies the revision level of the firmware that resides on the voice option
module.