Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 2)

ii
Copyright Notice
Copyright © 2001 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or about its products or
services. Verilink’s sole warranty is contained in its product warranty. The end-user documentation is
shipped with Verilink’s products and constitutes the sole specifications referred to in the product war-
ranty. Verilink has made reasonable efforts to verify that the information contained herein is accurate,
but Verilink assumes no responsibility for its use or for any infringement of patents or other rights of
third parties that may result. The customer is solely responsible for verifying the suitability of Ver-
ilink’s products for its use. Specifications are subject to change without notice.
Manual reorder # 34 - 00208
Revision L, September 2003
Trademarks
Verilink and the Verilink logo are registered trademarks of Verilink Corporation.
Ethernet is a registered trademark of Xerox Corporation.
MEGACOM and SLC are registered trademarks of AT&T.
OpenView is a registered trademark of Hewlett-Packard Company.
SNMPc is a trademark of Castle Rock Computing, Inc.
SunNet is a trademark of Sun Microsystems, Inc.
Any other named products herein are trademarks of their respective companies.
Acknowledgment
The software used in the SNMP function of this product contains material derived from the following
source:
Copyright © 1989 by the Regents of the University of California. All rights reserved.
Redistributions in binary form must reproduce the above copyright notice, this list of conditions, and
the following disclaimer in the documentation and /or other materials provided with the distribution.
All advertising materials mentioning features or use of this software must display the following
acknowledgment:
This product includes software developed by the University of California, Berkeley and its contributors.
Neither the name of the University nor the names of its contributors may be used to endorse or
promote products derived from this software without specific prior written permission.
This software is provided by the regents and contributors ‘as is’ and any express or implied warranties,
including, but not limited to, the implied warranties of merchantability and fitness for a particular pur-
pose are disclaimed. In no event shall the regents or contributors be liable for any direct, indirect, inci-
dental, special, exemplary, or consequential damages (including, but not limited to, procurement of
substitute goods or services; loss of use, data, or profits; or business interruption) however caused and
on any theory of liability, whether in contract, strict liability, or tort (including negligence or otherwise)
arising in any way out of the use of this software, even if advised of the possibility of such damage.
FCC
Requirements
This equipment has been tested and found to comply with the limits for a Class A digital device, pursu-
ant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user is required
to correct the interference at his own expense.
Shielded cables must be used to ensure compliance with the Class A FCC limits.
Caution: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device comples with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
✦ This device may not cause harmful interference.
✦ This device must accept any interference received, including interference that may cause undesired
operation.
✍
✍ ✍