Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 79)

Configuration Screens 69
SNMP
Parameters
The SNMP Configuration screen (Figure 4-13) is accessible if the unit is equipped
with the Ethernet or Token Ring SNMP interface. It allows for the entry of those
parameters required for proper operation with an Ethernet or Token Ring -based
LAN manager.
Element
Toggling this field with the spacebar accesses either the NEAR or FAR unit.
Reset LAN Interface
For changes to take effect, reset the LAN interface or cycle the unit’s power.
Selecting this field brings up a confirmation screen that asks if you want to
proceed with the reset.
SNMP Sets
Enables or disables the set command responses. Refer to Appendix C for detailed
information on these responses.
Trap IP Address
Accepts the IP address of a network device where alarm reporting traps are to be
sent. Each of the four numbers range from 0 to 255 and is separated by a period.
The unit detects and reports T1 network alarms and provides several options for
reporting them, one of which is SNMP traps. When a network alarm occurs, the
unit sends a trap message to up to 6 destinations on the user’s network. The trap
message is formatted per RFC 1157. The generic trap type is enterpriseSpecific
(generic-trap = 7).
Figure 4-13 SNMP Parameters Screen
3030 DSU x.xx/x.xx PRISM 3030 Date: MM/DD/YY
No Far End Response (Unit Address: 23) Time: HH:MM:SS
------------------------------- SNMP CONFIGURATION -----------------------------
Element: [NEAR] (RESET LAN INTERFACE)
SNMP Sets: [ENABLE ]
Trap I.P. Address 1 (000.000.000.000)
Trap I.P. Address 2 (000.000.000.000)
Trap I.P. Address 3 (000.000.000.000)
Trap I.P. Address 4 (000.000.000.000)
Trap I.P. Address 5 (000.000.000.000)
Trap I.P. Address 6 (000.000.000.000)
Read Community (public )
Write Community (private )
System Contact (no system contact )
System Name (no system name )
System Location (no system location )
------------------------------------Messages------------------------------------
Local Screen