Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 56)

46 C HAPTER 4: T ERMINAL O PERATION
If the unit is called and sent the break command before receiving the connect
message, the modem hangs up.
Screen
Components
Terminal interface screens have several components common to all screens and is
discussed individually in the following paragraphs. These common elements are
shown in the Password Screen (Figure 4-1).
Device Type and Revision
The device type (the PRISM 3030) and the revision control numbers are shown in
the upper left corner. The first number is the hardware revision and the second
number is the software revision. Information is displayed for the near-end unit
(connected directly to the terminal) on the top line, and for the far-end unit
(connected to the network T1 interface) on the second line. Refer to this
information when contacting the factory with inquiries.
The far-end information is available only for Verilink products that support a
proprietary message set. If the far end does not support these messages but does
support the standard TR 54016 protocol, then the far-end information is displayed
as GENERIC 54016 FAR END. If the far end does not respond to either
proprietary or TR 54016 messages, then NO FAR END RESPONSE is displayed.
If the far end echoes the FDL messages transmitted by the near-end unit, then FAR
END LINE LOOP is displayed.
Date/Time
The top right corner of the terminal screen displays the date and time. Setting
these functions is described in Set Date on page 74 and Set Time on page 74.
✍
Figure 4-1 Password Screen
3030 DSU x.xx/x.xx PRISM 3030 Date: MM/DD/YY
No Far End Response (Unit Address: 23) Time: HH:MM:SS
------------------------------- PASSWORD SCREEN --------------------------------
Enter Password: (**********)
Start Date: MM/DD/YY
Start Time: HH:MM:SS
------------------------------------Messages------------------------------------
Local Screen