Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 78)

68 C HAPTER 4: T ERMINAL O PERATION
TCP/IP
Parameters
The TCP/IP Configuration screen (Figure 4-12) is accessible for the Ethernet or
Token Ring SNMP interface. It allows for the entry of those parameters required
for proper operation with an Ethernet or Token Ring-based LAN manager.
Ethernet/Token Ring
If applicable, this field displays the Ethernet or Token Ring hardware/software
revision level.
Element
Toggling this field with the spacebar accesses either the NEAR or FAR unit.
Reset LAN Interface
For changes to take effect, the unit must be restarted. Selecting this field brings up
a confirmation screen that asks if you want to proceed with the reset.
PRISM IP Address
Accepts IP addresses. Each device connected to the LAN is required to have a
unique IP address identifier.
Subnet Mask
Provided to manually override the subnet mask setting which is otherwise
discovered by the SNMP agent.
Router IP Address
Accepts the IP address of the default router.
Filter IP Address
These eight fields accept the IP address of the source packet filter. If any of these
fields are set, access is allowed only by the specified IP addresses.
Figure 4-12 TCP/IP Parameters Screen
3030 DSU x.xx/x.xx PRISM 3030 Date: MM/DD/YY
No Far End Response (Unit Address: 23) Time: HH:MM:SS
----------------------------- TCP/IP CONFIGURATION -----------------------------
Ethernet 255.255/X.XX
Element: [NEAR] (RESET LAN INTERFACE)
I.P. Address (000.000.000.000)
Subnet Mask (000.000.000.000)
Router I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
Filter I.P. Address (000.000.000.000)
------------------------------------Messages------------------------------------
Local Screen