Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 84)

74 C HAPTER 4: T ERMINAL O PERATION
Utilities Screen The Utilities screen (Figure 4-15) handles the functions described in the following
paragraphs.
General
Functions
Set Time
Set the time using the 24 -hour HH : MM :SS format. For example, 3:45 a.m. is
entered as 0345 and 3:45 PM is entered as 1545.
Set Date
Set the date using the MM: DD :YY format. For example, July 4, 1993 is entered
as 070493.
The time and date can be set at the far end, but not displayed.
New Password
Allows entry of a password of up to 10 characters. An empty string (carriage
return only) disables the password feature. After Enter is pressed, the new
password is activated and is no longer visible. Therefore, type carefully when
entering a new password and verify before pressing Enter. When the terminal
interface is exited and later reactivated, this password must be entered exactly to
gain access. If the wrong password is entered, the following message appears.
Incorrect Password; Please Enter Again.
Do not exit the terminal interface program until the password procedure is fully
understood. If a password has been specified, it must be typed exactly to reenter the
program.
If a password is programmed and later forgotten, the password can be cleared
through the front panel maintenance reset (see Maintenance Reset on page 22).
Figure 4-15 Utilities Screen
3030 DSU x.xx/x.xx PRISM 3030 Date: MM/DD/YY
No Far End Response (Unit Address: 23) Time: HH:MM:SS
------------------------------------ UTILITIES ---------------------------------
Element: [NEAR]
Set Time: (12:34:25)
Set Date: (04/30/93)
Alarm Notification: [DIAL ]
Primary Phone#: (205-555-1212 )
Secondary Phone#: (205-532-8853 )
Element ID: (DSU 1230 )
New Password: (JohnDoe )
(MAINTENANCE RESET)
------------------------------------Messages------------------------------------
Local Screen
✍
✍