Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 127)

V T 1 0 0 I n t e r f a c e 4-5
New Password
Enter a new password in “New Password” to modify your password.
Acceptable characters for use in a password are digits 0–9 and letters A–Z
and a–z, for a total of 62 distinct characters.
Maintenance Reset
Select this prompt to perform a Maintenance Reset (Packet or TDM) as
shown in Figure 4.4. All configurations will be lost and the unit will be set
back to factory defaults. Selecting one of the Maintenance Reset prompts will
display a confirmation screen where you will choose either to proceed with
the maintenance reset or not.
Figure 4.4 Maintenance Reset Screen
Using the space bar, you may toggle through the options to select the desired
maintenance reset (Default TDM Configuration, Default Packet Configuration,
Default Packet 3 Configuration, or Default Packet 4 Configuration). After you
select an option, the unit will display a confirmation screen (Figure 4.4) where
you may choose either to proceed with the maintenance reset or not.
NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit. Refresh (by pressing
“Ctrl+U”) after approximately 10 seconds to restore communications.
Save and Restart
Selecting “Save and Restart” will display a confirmation menu (Figure 4.6).
Select “yes” to save the current configuration settings and then restart the
unit.