Verilink WANsuite 7205 (34-00317.B) Product Manual User Manual
Page 41
W e b S e r v e r I n t e r f a c e
3-11
be set by configuring the next four parameters (Start Channel, Number of
Channels, Bundling, and Channel Rate).
Values: Synchronous, nx 64 kbps (where n = 1–32) or nx56 kbps (where
n = 1
−
31); or asynchronous, 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200 bps
Default: 1984000 bps
Bundling
Selects whether the DTE channel assignment is made as a “Contiguous”
group or as “Alternate” channels. Selecting “Alternate” ensures ones density.
Because the unit allows individual channels to be configured for a service, a
value of “Arbitrary” will be returned for this parameter if the current channel
allocation is not contiguous or Alternate. The “Arbitrary” value can only be
supplied by the unit
−
it cannot be set by the user.
Values: Contiguous, Alternate, Arbitrary
Default: Contiguous
NOTICE:
Because “Alternate” Bundling assigns every other channel, only half
the channels are available.
Start Channel
Selects the starting channel in the 31-channel DS1 bit stream. Starting with
the specified channel, the unit automatically assigns the channels that follow.
Number of Channels
Specifies the number of channels to be assigned to the DTE.
Channel Rate
The unit can operate at any data rate that is a multiple of 56 or 64 kbps. If
“
Ν
x64K” is selected, the ones density requirements of the E1 network line
must be ensured. If “
Ν
x56K” is selected, ones density for the selected DS0
channel is maintained.
Values: Nx56K, Nx64K
Default: Nx64K
NOTICE:
Start Channel, Number of Channels, and Channel Rate cannot be
changed if Bundling is not also changed from “Arbitrary.”
Invert Clock
(Applies to Serial 2
Screen Only)
In DTE Packet mode, this parameter changes the clock edge of the
transmitted data. The Invert Clock parameter is only available for use in DTE
mode on the Serial 2 port. Consequently, this configuration option should
remain disabled when configuring services for the Serial 1 port.
Values: Disable, Enable
Default: Disable
Unframed
CCS
CAS
Values
0
1
−
31
1
−
15, 17
−
31
Default
0
1
1
Unframed
CCS
CAS
Values
0 or 32
0
−
31
0-30
Default
0
31
30