Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 86)

3-56 W A N s u i t e 7 2 0 5
equal cost multipath routing where packets to a single destination can be sent
via more than one interface simultaneously.
Figure 3.44 IP Gateway Screen
RIP Parameters
RIP Enable Globally enables RIP1, RIP2, or No RIP.
Values: Disable, Enable RIP1, Enable RIP2
Default: Enable RIP2
RIP Trust Neighbors Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
RIP Interval Interval for RIP packet to be sent. Default is 30 seconds.
RIP Domain Value representing the RIP domain. Default is 0.
OSPF Parameters
OSPF Enable Globally enables OSPF.
Values: Disable, Enable
Default: Disable