Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 35)

W e b S e r v e r I n t e r f a c e 3-5
Figure 3.4 Network 2 Screen
Function (Network 2
Only)
In the “Slaved” function, Network 2 is slaved and receives its timing from the
same source from which Network 1 receives its timing. In the Network
function, Network 2 is an independent network and can only be connected to
Serial 2 in TDM mode.
Values: Slaved, Network
Default: Slaved
NOTICE: The “Function” parameter fundamentally affects the operation of the
unit. Even though this parameter is found only on the Network 2 screen,
its setting affects all three Network ports and the Service table.
Framing Selects the framing for the Network side of the DSU/CSU.
Values CCS, CAS, Unframed
Default: CCS
Coding Sets the Network side line coding.
Values: HDB3, AMI
Default: HDB3
Timing Sets the timing source to synchronize the unit’s internal timing generators. In
all cases, slips are controlled to occur on frame boundaries at the Network
ports when timing synchronization is lost. The options are as follows:
Network 1
“Function” parameter (on the Network 2 screen) in “Slaved” mode
−
Internal,
Network 1, Network 2, Network 3, Serial 1, Serial 2