Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 180)

4-58 W A N s u i t e 7 2 0 5
Figure 4.49 Routes Details Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the Target IP or network.
Next Hop IP Address: IP address of the next device in the route.
NOTICE: Setting the Target IP Address and Target IP Mask to 0.0.0.0 defines
THE default route for this unit.
Cost Cost of using that route.
Route Status Indicates whether this route is enabled or disabled.
Dynamic Route Table Screen
Access this menu by clicking on the “Static Route Table” on the IP Gateway
menu and then selecting Dynamic Route Table. This table shows both
dynamic and static routes. Please note that not all parameters are necessarily
defined, depending on whether or not the routes were learned dynamically.
Primarily, the most useful information is included in "Destination," "If Ndx,"
and "Mask" columns.