Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 27)

I n s t a l l a t i o n 2-1
C H A P T E R
2
C HAPTER 2
I
NSTALLATION
This chapter describes the contents of your WANsuite 7205 shipment and
provides information on connecting and installing the unit.
The WANsuite 7205 uses an “Installation Wizard” to help you automatically
install the unit quickly and correctly. Procedures for using this Installation
Wizard are also described in this chapter.
For information on installing and replacing shelves, modules, and power
supplies, refer to the Verilink manual AS2000, The Basics.
WANsuite 7205 Components
The complete WANsuite 7205 assembly consists of an application module
and a rear data interface module (DIM), together occupying a single shelf-slot
position accessible from the front and back of the Verilink AS2000 rack or
shelf. The DIM is installed from the rear of the shelf into the backplane. The
WANsuite 7205 front module is installed from the front. The DIM is always
installed first and removed last; the WANsuite 7205 front module is installed
last and removed first.
Unpacking and Inspection
The WANsuite 7205 is shipped in cardboard cartons with foam inserts for
shock and vibration protection. When your shipment arrives, inspect the
shipping container and contents, and compare all items with those listed on
the packing list.
If the contents of the shipment are incomplete or if there is mechanical
damage or defect, notify the carrier and Verilink. (See Support from Verilink
on page xii.) If the shipping container or cushioning material is damaged,
notify the carrier and Verilink immediately and make a notation on the
delivery receipt that the container was damaged. (If possible, obtain the
signature and name of the person making delivery.) Retain the packaging
material until the contents of the shipment have been checked for