Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 137)

V T 1 0 0 I n t e r f a c e 4-15
Format Selects the port’s operating mode.
Values: Sync, Async
Default: Sync
Flow Control Selects the type of flow control to be used if the port is asynchronous.
Values: None, Xon/Xoff, RTS/CTS
Default: None
Character Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity Sets the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the asynchronous character.
Values: 1, 2
Default: 1
Current Pin Status Shows the status of the DTE Serial port pins.
Ethernet (IP Details) Screen
If you select “Ethernet” from the Interfaces screen, you will bring up an IP
Details screen (Figure 4.11) that lets you view and/or modify the IP
parameters listed below.
Figure 4.11 10/100 Ethernet (IP Details) Screen
Unit IP Address A unique network address assigned to this unit.
Subnet Mask Defines the network portion of the unit’s IP address.
Gateway IP Address IP address of the default gateway (router) on the LAN side of the unit.