Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 140)

4-18 W A N s u i t e 7 2 0 5
screen (Figure 4.14) from the <Index> column, to an Interface Details screen
from the <Interface> column, or to a Type Details screen from the <Type>
column.
Figure 4.14 Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you press the “Esc” key and return to the
previous screen.
Interface Selecting one of the interfaces will bring up a screen where you can view
(and, in some cases, change) interface parameters. These screens are the same
ones displayed when you select a sub-menu from the Interfaces menu
described earlier on page 4-6.
Type Selecting one of the services listed under the “Type” column will bring up a
screen where you can view (and, in some cases, change) parameters for each
type of service. The details displayed depend on the type of service currently
in effect. These screens are shown and described below according to each
type of service.
Pair User-assigned integer field that specifies where to route the traffic from this
service. If the service is terminated by the unit, set this value to “0” (zero).
Delete Service Select “Delete Service” to remove the currently configured service identified
by the Service Details screen. Deleting the selected service will remove all
references to this service. These references may include Channel, Frame
Relay, DLCI, Endpoint, and Service Aware configurations.
After selecting “Delete Service,” you will be presented with a confirmation
screen similar to the one shown in Figure 4.4. Select “Yes” to confirm
removal of the selected service.