Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 162)

4-40 W A N s u i t e 7 2 0 5
Remote Unit If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery
is enabled, this field displays the first three digits of the unit ID configured on
the remote end of this DLCI.
Values: 000
−
999
Default: 000
Remote IP Address Displays the IP address of the unit configured on the remote end of this
DLCI.
Round Trip Delay Specifies the frame size (in bytes) of packets making round-trip.
Round Trip Rate Specifies the rate (in seconds) at which Round Trip Delay packets are sent.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of this
DLCI and alarm threshold information as follows:
Status If this DLCI is up, the status will be “Active”; otherwise, the status will be
“Inactive.”
Values: Active, Inactive
Default: Inactive
Receiving FECN/
BECN
When a frame is received with congestion bit set, this parameter is set to
“Yes.” It is set back to “No” when a frame is received without congestion bit
set.
Values: Yes, No
Default: No
CIR Threshold Sets the Tx over CIR alarm threshold. This threshold is the number of bits per
second in excess of CIR during a 15-minute interval. Setting this field to “0”
(zero) disables the alarm.
CIR Alarm Reports if the Tx over CIR threshold has been exceeded.
Bits Over Be Threshold Sets the Tx over excess burst alarm threshold. This threshold is the number of
bits per second in excess of CIR + Be during a 15-minute interval. Setting
this field to “0” (zero) disables the alarm.
Bits Over Be Alarm Reports if the Tx over Be threshold has been exceeded.
Congestion Threshold Sets the Rx Congestion alarm threshold. This threshold is the number of
frames received with BECN/FECN. Setting this field to “0” (zero) disables
the alarm.
Congestion Alarm Reports if the Rx Congestion threshold has been exceeded.
BECN in CIR Reports if Backward Explicit Congestion Notification (BECN) has been
received within CIR.