Westermo MRD-3x0 User Manual
Page 136
136
6623-3201
Enable IPsec
To complete the configuration in the General IPsec
Configuration enable IPsec by checking the enabled check-box,
and as the tunnel will traverse a NAT enable NAT traversal.
Click Update to save the settings.
Figure 99: IPsec based VPN main page, with IPsec enabled.
IPsec Status
Once the settings have been save IPsec will start and attempt
to establish a tunnel with the remote host, note this may take
several minutes to complete. To check the status of the tunnel
click Status on the main menu then VPN on the sub-menu, a
page similar to that shown in Figure 100 will be displayed. If
the Status of the tunnel is Connected then the tunnel has been
established and data can be passed over it.
To obtain further details on the VPN connection click the link
Detailed IPsec status, a page similar to that shown in Figure
101 will be displayed. This information is usually only required
if the link is not behaving as expected or if the tunnel is not
able to be established.