Westermo MRD-3x0 - Manual (Page 40)

40 6623-3201
3.3.1 Connection Establishment
The connection establishment options are used to set the
parameters for initial connection to a providers wireless net-
work. The options are:
Timeout for network initialisation:
Specify the maximum time in seconds to allow for a network
initialisation, the minimum value accepted is 60 Seconds.
Timeout for connection establishment:
Specify the maximum time in seconds to allow for a con-
nection to be established, the minimum value accepted is 30
Seconds.
Remote poll required for successful connection:
Specify if a remote poll should be completed before consider-
ing the connection successful. If this option is set to Yes then
the Remote Poll Setup must be enabled and configured cor-
rectly, refer to section 3.3.3
Timeout between remote poll attempts:
Specify the time in seconds to wait between successive
polls should a poll fail. This option is only available when the
Remote poll required for successful connection option is set
to Yes.
Failed establishment attempts before RF restart:
Specify the number of failed connection attempts before
restarting the RF circuitry. Set this value to 0 to disable RF
Circuitry reset.
Failed establishment attempts before unit reboot:
Specify the number of failed connection attempts before
resetting the MRD-3xx. Set this value to 0 to disable the
MRD-3xx reset.
Failed establishment attempts before dropping to CSD:
Specify the number of failed connection attempts before
switching to Circuit Switched Data (CSD) mode. Set this value
to 0 to disable the fail-over to CSD feature.