Westermo MRD-3x0 - Manual (Page 168)

168 6623-3201
As shown in Figure: 122, the following options can be set for
Raw UDP mode:
Send address
This is the address the serial server will send UDP packets to.
The address entered should be in IPv4 decimal dotted nota-
tion.
Send port
This is the UDP port number the server will send UDP pack-
ets to. The value entered should be a valid UDP port number.
Local receive port
This is the UDP port number that UDP packets will be
received on at the unit. The value entered should be a valid
UDP port number.
For information on setting the Port Configuration, see section
7.2.1. For information on setting the Packet Framing, see sec-
tion 7.2.2.