H3C Technologies H3C S6800 Series Switches - Manual (Page 131)

118
Figure 33 Network diagram
Table 8 Interface and IP address assignment
Device Interface IP address Device Interface IP address
Switch A Loop0 1.1.1.1/32 Switch E Loop0 5.5.5.5/32
Vlan-int1 2.1.1.1/24 Vlan-int4 3.2.1.2/24
Switch B Loop0 2.2.2.2/32 Vlan-int5 3.4.1.1/24
Vlan-int1 2.1.1.2/24 Switch C Loop0 3.3.3.3/32
Vlan-int2 3.1.1.1/24 Vlan-int3 4.1.1.1/24
Vlan-int4 3.2.1.1/24 Vlan-int2 3.1.1.2/24
Vlan-int6 3.3.1.1/24 Vlan-int5 3.4.1.2/24
Switch D Loop0 4.4.4.4/32 Switch F Loop0 6.6.6.6/32
Vlan-int3 4.1.1.2/24 Vlan-int6 3.3.1.2/24
Vlan-int7 4.2.1.2/24 Vlan-int7 4.2.1.1/24
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address. (Details
not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each switch. Enable BFD for
RSVP-TE on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] mpls lsr-id 1.1.1.1
文件中找不到关系 ID 为 rId48 的图像部件。