H3C Technologies H3C S6800 Series Switches User Manual
Page 416
403
[NPE2] mpls ldp
[NPE2–ldp] quit
# Enable L2VPN.
[NPE2] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish N-PWs to NPE 1
and NPE 3.
[NPE2] vsi aaa
[NPE2-vsi-aaa] pwsignal ldp
[NPE2-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500
[NPE2-vsi-aaa-ldp-2.2.2.9-500] quit
[NPE2-vsi-aaa-ldp] peer 4.4.4.9 pw-id 500
[NPE2-vsi-aaa-ldp-4.4.4.9-500] quit
[NPE2-vsi-aaa-ldp] quit
[NPE2-vsi-aaa] quit
# Create service instance 10 on FortyGigE 1/0/1 to match all packets.
[NPE2] interface fortygige1/0/1
[NPE2-FortyGigE1/0/1] service-instance 10
[NPE2-FortyGigE1/0/1-srv10] encapsulation default
# Bind service instance 10 to the VSI aaa.
[NPE2-FortyGigE1/0/1-srv10] xconnect vsi aaa
5.
Configure NPE 3:
# Configure basic MPLS.
<NPE3> system-view
[NPE3] interface loopback 0
[NPE3-LoopBack0] ip address 4.4.4.9 32
[NPE3-LoopBack0] quit
[NPE3] mpls lsr-id 4.4.4.9
[NPE3] mpls ldp
[NPE3–ldp] quit
# Enable L2VPN.
[NPE3] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish N-PWs to NPE 1
and NPE 2.
[NPE3] vsi aaa
[NPE3-vsi-aaa] pwsignal ldp
[NPE3-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500
[NPE3-vsi-aaa-ldp-2.2.2.9-500] quit
[NPE3-vsi-aaa-ldp] peer 3.3.3.9 pw-id 500
[NPE3-vsi-aaa-ldp-3.3.3.9-500] quit
[NPE3-vsi-aaa-ldp] quit
[NPE3-vsi-aaa] quit
# Create service instance 10 on FortyGigE 1/0/1 to match all packets.
[NPE3] interface fortygige1/0/1
[NPE3-FortyGigE1/0/1] service-instance 10
[NPE3-FortyGigE1/0/1-srv10] encapsulation default
# Bind service instance 10 to the VSI aaa.