H3C Technologies H3C S6800 Series Switches - Manual (Page 454)

441
Step Command Remarks
6. Redistribute the IGP routes
of the VPN into BGP.
import-route protocol
[ { process-id | all-processes }
[ med med-value | route-policy
route-policy-name ] * ]
By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN
network addresses to the
connected MCE.
Configuring routing between an MCE and a PE
MCE-PE routing configuration includes the following tasks:
• Binding the MCE-PE interfaces to VPN instances.
• Performing route configurations.
• Redistributing VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configurations on the MCE. Configure the PE in the same way that a PE in a basic
MPLS L3VPN is configured. For more information about configuring the PE, see " Configuring MPLS
L3VPN ."
Configuring static routing between an MCE and a PE
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure a static route
for a VPN instance.
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
By default, no static
route is configured.
3. (Optional.) Configure
the default preference for
static routes.
ip route-static default-preference
default-preference-value The default preference is
60.
Configuring RIP between an MCE and a PE
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a RIP process for
a VPN instance and
enter RIP view.
rip [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Enable RIP on the
interface attached to
the specified network.
network network-address
By default, RIP is disabled on
an interface.