H3C Technologies H3C S6800 Series Switches - Manual (Page 479)

466
Step Command Remarks
10. Enter interface view.
interface interface-type
interface-number
N/A
11. Enable the OSPFv3 process
on the interface. ospfv3 process-id area area-id
[ instance instance-id ] By default, OSPFv3 is disabled on
an interface.
Configuring IPv6 IS-IS between an MCE and a PE
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an IS-IS process for an
IPv6 VPN instance and enter
IS-IS view.
isis [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Configure a network entity
title.
network-entity net By default, no NET is configured.
4. Enable IPv6 for the IS-IS
process.
ipv6 enable By default, IPv6 is disabled.
5. (Optional.) Redistribute VPN
routes.
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
By default, IPv6 IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table.
6. (Optional.) Configure filtering
of advertised routes.
ipv6 filter-policy { acl6-number |
prefix-list prefix-list-name |
route-policy route-policy-name }
export [ protocol [ process-id ] ]
By default, IPv6 IS-IS does not filter
advertised routes.
7. Return to system view. quit N/A
8. Enter interface view.
interface interface-type
interface-number
N/A
9. Enable the IPv6 IS-IS process
on the interface.
isis ipv6 enable [ process-id ]
By default, IPv6 IS-IS is disabled on
an interface.
Configuring EBGP between an MCE and a PE
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter BGP-VPN instance view. ip vpn-instance vpn-instance-name N/A
4. Configure the PE as an EBGP
peer.
peer { group-name | ipv6-address
[ prefix-length ] } as-number
as-number
By default, no BGP peer is
configured.
5. Enter BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A