Binding an ac to a vsi, Configuring upe dual homing, Required.) – H3C Technologies H3C S6800 Series Switches User Manual
Page 395
382
Step Command
Remarks
5.
Configure route targets for the
auto-discovery VSI.
vpn-target vpn-target&<1-8> [ both
| export-extcommunity |
import-extcommunity ]
By default, no route targets are
configured for the auto-discovery
VSI.
6.
(Optional.) Reference a PW
class.
pw-class class-name
By default, no PW class is
referenced.
7.
(Optional.) Reference a tunnel
policy.
tunnel-policy tunnel-policy-name
By default, no tunnel policy is
referenced.
8.
Use LDP to create a PW to an
automatically discovered
remote PE and enter
auto-discovery VSI LDP
signaling view.
signaling-protocol ldp
By default, no signaling protocol is
specified.
9.
Configure a VPLS ID for the
VSI.
vpls-id vpls-id
By default, no VPLS ID is
configured.
Binding an AC to a VSI
This task is mutually exclusive from Ethernet link aggregation. If a Layer 2 Ethernet interface has been
added to a link aggregation group, you cannot bind a service instance on the interface to a VSI, and
vice versa.
On a Layer 2 Ethernet or Layer 2 aggregate interface, you can create a service instance and bind it to
a VSI. The service instance matches packets received on that interface. The matching packets are then
forwarded based on the MAC address table of the VSI. A service instance can match all packets, tagged
packets, or untagged packets.
To bind a service instance to a VSI:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
•
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
N/A
3.
Create an Ethernet service
instance and enter Ethernet
service instance view.
service-instance instance-id
By default, no Ethernet
service instance exists on the
interface.
4.
Bind the Ethernet service
instance to a VSI.
xconnect vsi vsi-name [ access-mode
{ ethernet | vlan } ]
By default, a service instance
is not bound to any VSI.
Configuring UPE dual homing
This task includes the following configurations: