H3C Technologies H3C S6800 Series Switches - Manual (Page 272)

259
[SPE2-bgp] address-family vpnv4
[SPE2-bgp-vpnv4] peer 4.4.4.9 upe route-policy hope export
Verifying the configuration
# Verify that CE 1 and CE3 can learn each other's interface routes and can ping each other. CE 2 and
CE 4 cannot learn each other's interface routes and cannot ping each other. (Details not shown.)
Configuring an OSPF sham link
Network requirements
As shown in Figure 70 , CE 1 and CE 2 belong to VPN 1. Configure an OSPF sham link between PE 1 and
PE 2 so traffic between CE 1 and CE 2 is forwarded through the MPLS backbone, instead of the
backdoor link.
Figure 70 Network diagram
Table 20 Interface and IP address assignment
Device Interface IP address Device Interface IP address
CE 1 Vlan-int11 100.1.1.1/24 CE 2 Vlan-int11 120.1.1.1/24
Vlan-int13 20.1.1.1/24 Vlan-int12 30.1.1.2/24
PE 1 Loop0 1.1.1.9/32 PE 2 Loop0 2.2.2.9/32
Loop1 3.3.3.3/32 Loop1 5.5.5.5/32
Vlan-int11 100.1.1.2/24 Vlan-int11 120.1.1.2/24
Vlan-int12 10.1.1.1/24 Vlan-int12 10.1.1.2/24
Switch A Vlan-int11 20.1.1.2/24
Vlan-int12 30.1.1.1/24
Configuration procedure
1. Configure OSPF on the customer networks:
文件中找不到关系 ID 为 rId92 的图像部件。