HEIDENHAIN ND 1300 OED and Crosshair Systems - Manual (Page 240)

222 QC-300 Series User’s Guide
Reports are not printed or are incomplete
Probable cause 1: The channel input device is not connected
or is malfunctioning
Possible solution:
1 The printer is not supported by the QC-300.
Probable cause 2: The USB cable is not firmly connected or
is damaged
Possible solution:
1 Connect or replace the printer cable.
Probable cause 3: The printed report setup is incorrect
Possible solution:
1 Correct the report setup in the Print setup screen.
Probable cause 4: The printer is not supported
Solution:
1 Contact Metronics for a list of supported printers.
Reports are printed incorrectly
Probable cause 1: The printed report setup is incorrect
Possible solution:
1 Correct the report setup in the Print setup screen.
Probable cause 2: The wrong control characters are specified
Possible solution:
1 Correct the control character configurations in the Print setup screen.