HEIDENHAIN IK 5293 - Manual (Page 348)

334
Chapter 8 Setup
Encoder setup shows numerous errors after calibrating an axis
NOTE NOTE NOTE NOTE NOTE
Check the Windows NT taskbar to be certain no other copies of Check the Windows NT taskbar to be certain no other copies of Check the Windows NT taskbar to be certain no other copies of Check the Windows NT taskbar to be certain no other copies of Check the Windows NT taskbar to be certain no other copies of
QC5000 or Encoder Setup are running.
QC5000 or Encoder Setup are running. QC5000 or Encoder Setup are running. QC5000 or Encoder Setup are running. QC5000 or Encoder Setup are running.
Step 1
Re-calibrate the axis using a smooth, continuous, back-and-forth motion.
NOTE NOTE NOTE NOTE NOTE
If re-calibrating the axis does not solve the problem continue to If re-calibrating the axis does not solve the problem continue to If re-calibrating the axis does not solve the problem continue to If re-calibrating the axis does not solve the problem continue to If re-calibrating the axis does not solve the problem continue to
step 2.
step 2. step 2. step 2. step 2.
Step 2
Check all other axes for calibration problems.
NOTE NOTE NOTE NOTE NOTE
Discontinue troubleshooting and contact your distributor/OEM Discontinue troubleshooting and contact your distributor/OEM Discontinue troubleshooting and contact your distributor/OEM Discontinue troubleshooting and contact your distributor/OEM Discontinue troubleshooting and contact your distributor/OEM
if no axis will calibrate properly
if no axis will calibrate properly if no axis will calibrate properly if no axis will calibrate properly if no axis will calibrate properly.....