Yaskawa E7B Drive Bypass - Manual (Page 69)

Control Panel 3 - 5
Drive Run Indicator
The status of the “RUN” indicator is shown in Table 3.4 when the Drive is either in the “Hand” or “Auto” mode.
Drive Stop Indicator
The status of the “STOP” indicator is shown in Table 3.5 when the Drive is either in the “Hand” or “Auto” mode.
Control Panel Indicator Lights
Control Power Indicator
Drive Run Indicator
Table 3.4 RUN Indicator
Indicator Status Description
On Drive is running
Blinking Drive is decelerating to a stop
Off Drive is stopped
Table 3.5 STOP Indicator
Indicator Status Description
On Drive is decelerating to a stop or stopped
Blinking Drive is in a run condition but the speed command is zero
Off Drive is running
Table 3.6 Control Power Indicator
Indicator Status Condition
On
3 Phase Power is applied to the Bypass unit and the control power
transformer is functioning.
Off
3 Phase Power is disconnected from the Bypass unit or a control
power transformer fuse has cleared.
Table 3.7 Drive Run Indicator
Indicator Status Condition
On
The Drive has been given a run command in hand or auto mode and
the Bypass circuit is de-energized.
Off
The Drive has no run command in either the hand or auto modes. The
unit may be operating in Bypass mode.