TA Triumph-Adler LP 210 - Manual (Page 94)

6 Working with the DOS printer tools
6-20 Laser Printer 200 Series
Switching on/off the Power Save mode
In order to save energy, the printer automatically switches to the Power
Save mode after a certain period of inactivity. When the printer receives a
new command or the control button is pressed while in this mode, the
printer automatically switches to the warm-up phase.
➜ Select “ON“ and enter a time period after which the printer should
switch to the Power Save mode.
➜ Select “OFF“ to deactivate the Power Save mode function.
Switching on/off the paper format error detection
You can specify whether the printer should respond when the paper fed
into the machine is different to the one set in the printer driver.
➜ Select “ON“ to detect paper format errors.
➜ Select “OFF“ to ignore paper format errors.
Activating page protection
With page protection activated, the printer reserves extra memory space
and waits until the data for a page has been completely loaded into the
printer memory. Only then does the printing process begin.
➜ Select “AUTO“ to enable the printer to check each page of a print job
in advance and activate page protection if necessary.
➜ Select “ON“ to enable the printer to always reserve sufficient memory
so that the data for one page can be completely loaded. This function
requires min. 6 MB RAM for resolution of 600 x 600 dpi.