TA Triumph-Adler LP 4140 - Manual (Page 117)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-89
4 Press
U or V repeatedly until >Sleep
timer > appears.
5 Press Z and display >>Auto Sleep.
6 Press [OK]. A blinking question mark (?)
appears.
7 Select Off using U or V.
8 Press [OK].
9 Press [MENU]. The message display returns to Ready.
Sleep Timer Timeout Time
You can adjust the timer value, the length of time the printer waits before
entering sleeping mode in the absence of data.
1 Press [MENU].
2 Press U or V repeatedly until Others >
appears.
3 Press Z.
4 Press U or V repeatedly until >Sleep
timer > appears. The default setting is
015 min .
5 Press [OK]. A blinking cursor ( _ ) appears.
6 Press U or V to increase or decrease the value of the figure where the
cursor is blinking and set the desired time. The timer can be set between
5 and 240 min, in 5-minute increments. You can use
Z and Y to move the
cursor right and left.
7 Press [OK].
8 Press [MENU]. The message display returns to Ready.
>Sleep timer >
015 min.
>>Auto Sleep
On
>>Auto Sleep
? On
>>Auto Sleep
? Off
Others >
>Sleep timer >
015 min.
>Sleep timer >
015 min.