Removing memory module, Testing the expanded memory – TA Triumph-Adler LP 4140 User Manual
Page 146
Options
4-14 ADVANCED OPERATION GUIDE
7
When you finish installing the DIMM, mount the memory slot cover and
fasten it with the screw.
Removing Memory Module
To remove a memory module, carefully pull the end clips outwards, then
pull the memory module out of the socket.
Testing the Expanded Memory
After you finish installing DIMMs in the printer, test the printer to see if the
installation was successful. To test the expansion memory, proceed as
follows:
1
Make sure the printer is turned off. Plug the power cord into the printer and
turn the printer on.
2
Press [MENU] on the operation panel.
3
Press
U or V repeatedly until Print Status Page appears.
4
Press [OK] twice.
5
If the installation was successful, the amount of memory shown on the
status page will correspond with the amount of expanded memory. (The
factory installed memory size is 64 MB for LP 4140, 128 MB for
LP 4151.)