TA Triumph-Adler LP 4140 - Manual (Page 72)

Using the Operation Panel
2-44 ADVANCED OPERATION GUIDE
6 Press
Z. The message display changes to
that shown below. If >Print KPDL Errs
is displayed when the KPDL (AUTO)
emulation is selected, press
U or V to
change it.
7 Press [OK]. A blinking question mark (?)
appears.
8 Select On using U or V.
9 Press [OK].
10 Press [MENU]. The message display returns to Ready.
KC-GL Pen Width
The KC-GL emulation mode enables you to set the pen widths in dots, for
pen numbers 1 to 8, and the KC-GL page size.
1 Press [MENU].
2 Press U or V repeatedly until Emulation
appears on the message display.
3 If the current emulation is other than KC-
GL, press [OK]. A blinking question mark
(?) appears.
4 Press U or V repeatedly until KC-GL
appears.
5 Press [OK].
6 Press
Z to move to the >KC-GL Pen
Width submenu.
7 Press
Z.
>Print KPDL Errs
Off
>Print KPDL Errs
?Off
>Print KPDL Errs
?On
Emulation
PCL 6
Emulation
?PCL 6
Emulation
?KC-GL
Emulation
KC-GL
>KC-GL >
Pen Width
>>Pen(1) Width
01 dot(s)