TA Triumph-Adler LP 4140 - Manual (Page 89)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-61
Print Density
The print density can be adjusted in five steps: from 01 (light) to 05 (dark).
The factory setting is 03.
1 Press [MENU].
2 Press U or V repeatedly until Print
Quality > appears.
3 Press
Z.
4 Press U or V repeatedly until >Print
Density appears.
5 Press [OK]. A blinking question mark (?)
appears.
6 Select the print density from five steps from 01 (light) to 05 (dark) using
U
or V.
7 Press [OK].
8 Press [MENU]. The message display returns to Ready.
Print Quality >
>Print Density
03
>Print Density
? 03