TA Triumph-Adler LP 4140 - Manual (Page 122)

Using the Operation Panel
2-94 ADVANCED OPERATION GUIDE
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery time for Auto
Continue
.
1 Press [MENU].
2 Press
U or V repeatedly until Others >
appears.
3 Press
Z.
4 Press
U or V repeatedly until >Auto
Error Clear > appears.
5 Press
Z and display >>Error Clear.
6 Press [OK]. A blinking cursor (_) appears.
7 Press U or V to increase or decrease the value of the figure where the
cursor is blinking and set the desired time. The time must be set between
000 and 495 seconds, in 5-second increments. If set to 000, printing will be
continued immediately without allowing any time interval. You can use
Z
and Y to move the cursor right and left.
8 Display the desired time and press [OK].
9 Press [MENU]. The message display returns to Ready.
Others >
>Auto Error >
Clear On
>>Error Clear
Timer 030sec.