TA Triumph-Adler LP 4140 - Manual (Page 90)

Using the Operation Panel
2-62 ADVANCED OPERATION GUIDE
Operating the Storage Device
The printer supports four types of storage device; CompactFlash card,
USB flash memory, an option hard disk, and RAM disk. The CompactFlash
card and USB flash memory are installed into the dedicated slots of the
printer. The RAM disk is an allocated part of the printer’s memory. If an
option hard disk is installed in the printer, the e-MPS function will be
available. For details, refer to e-MPS on page 2-23.
The basic operations of each storage device are the same. This section
explains the operation of the CompactFlash card.
Using the CompactFlash Card
The printer is equipped with a slot for a memory card. By inserting a
memory card into the printer, the following operations become available.
For details about the handling of the memory card, refer to chapter 4
Options.
• Reading Font Data
• Reading Data
• Writing Data
• Deleting Data
• Formatting Memory card
• Printing of List of Partitions
Reading Font Data
If a memory card with the font data is already inserted into the slot when
the printer is turned on, the fonts are automatically read into the printer. To
re-read fonts into the printer from a memory card, proceed as follows.
1 Press [MENU].
2 Press
U or V repeatedly until Memory
Card > appears.
3 Press
Z.
4 Press
U or V repeatedly until >Read
Fonts appears.
5 Press [OK]. A blinking question mark (?)
appears.
Memory Card >
>Read Fonts
>Read Fonts ?