TA Triumph-Adler LP 4140 - Manual (Page 87)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-59
White vertical stripes
Set the KIR mode to On. Try printing the
status page again. If you still get white
vertical stripes, adjust the print density
control to a darker setting.
1 Press [MENU].
2 Press U or V repeatedly until Print
Quality > appears.
3 Press Z.
4 Press U or V repeatedly until >KIR Mode
appears.
5 Press [OK]. A blinking question mark (?)
appears.
6 Select On or Off using U or V.
7 Press [OK].
8 Press [MENU]. The message display returns to Ready.
EcoPrint
The EcoPrint enables you to reduce the amount of toner consumed on the
page so as to save your printing costs. You can set EcoPrint mode On, as
follows. (The factory default setting is Off.) The EcoPrint mode setting is
On
when the printing image becomes lighter, yet very readable.
NOTE: The EcoPrint setting has no effect on the print speed.
Print Quality >
>KIR Mode
On
>KIR Mode
? On
EcoPrint setting is
Off (default)
EcoPrint setting is
On