TA Triumph-Adler LP 4140 - Manual (Page 61)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-33
Maximum Space Assigned to Permanent Code Jobs
This changes the hard disk space that holds permanent code jobs. You
can change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free hard disk space, however. The
default size is 1/6 of the total hard disk space, rounded off in units of 50
MB. For example, if the total hard disk space is 3.2 GB, the default size is
500 MB.
1 Press [MENU].
2 Press U or V and select e-MPS >.
3 Press
Z.
4 Press U or V repeatedly until >e-MPS
Configuration > appears.
5 Press
Z.
6 Press U or V and select >>Perm. Code
JOB Size .
7 Press [OK], the message display shows a
blinking cursor (_).
8 Press
U or V to increase or decrease, respectively, the value at the
blinking cursor. Use Z and Y to move the cursor right and left.
9 When the desired size is displayed, press [OK].
10 Press [MENU] and the message display returns to Ready.
e-MPS >
>e-MPS >
Configuration
>>Perm. Code JOB
Size 0500MB
>>Perm. Code JOB
Size 0500MB