TA Triumph-Adler P-3020 MFP - Manual (Page 41)

2
Preparation before Use
2-7
Energy Saver Function
Low Power Mode
The device automatically enters Low Power Mode when 1 minute has passed since the device was last used.
The message display backlight turn off to reduce the power consumption. This status is referred to as Low Power
Mode.
If print data is received during Low Power Mode, the machine automatically wakes up and starts printing. Also when
fax data arrives while the machine is in Low Power Mode on products with the FAX function installed, the machine
automatically wakes up and starts printing.
To use the machine, press any key on the operation panel. The machine will be ready to use within 1 second. Note
that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
For information on the Low Power Mode settings, refer to Low Power Timer on page 8-35.
NOTE: When a preset time of Low Power Timer and Sleep Timer is same, Sleep Mode overrides Low Power Mode.
Sleep
When the set time (factory setting is 1 minute) elapses after the machine is last used, the machine automatically
enters sleep mode. The message display backlight and lights turn off to minimize power consumption. This status is
referred to as Sleep. When in the Sleep state, "Sleeping" appears in the message display.
There are two sleep modes (models except for Europe): Quick Recovery and Energy Saver. The default setting is
Energy Saver mode.
NOTE: When a preset time of Low Power Timer and Sleep Timer is same, Sleep Mode overrides Low Power Mode.
Quick Recovery Mode (models except for Europe)
The recovery from the sleep mode is faster than when using Energy Saver mode.
The machine recovers quickly when any key on the operation panel is pressed. The machine also automatically
recovers and prints when a job is detected.
If print data is received during Sleep, the print job is performed while the message display remains unlit.
To use the machine, press any key on the operation panel.
For more information about configuring settings, refer to Sleep Level (models except for Europe) on page 8-37.
Energy Saver Mode (models except for Europe)
This mode reduces power consumption even more than quick recovery mode, and allows Sleep mode to be set
separately for each function.
To use the machine, press any key on the operation panel. The machine will be ready to use within 15 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
For more information on Energy Saver settings, refer to Sleep Level (models except for Europe) on page 8-37