PLANET EPL-1000 - Manual (Page 24)

be appropriate. If on the other hand you wish to change them to match you local network,
you may do so as follows:
To change the IP Address assigned to the Host PC (this must match the Host PC IP
Address):
1) 3721/>pers [Enter]
2) 3721/pers/>hostip 192 168 1 100 [Enter]
To change the IP Address that is assigned to the OLT management port:
1) 3721/pers/>mgmtip 192 168 1 101 [Enter]
If you are not using Class C Addresses, you should also change the netmask to suit:
1) 3721/pers/>netmask 255 255 255 0 [Enter]
To make the new settings take effect you must reboot.
Prior to installing the GUI, you must set up your network adapter’s IP address to match the
setting found in the OLT’s personality flash (default = 192.168.1.100). Set the adapter’s IP
to match the value found in the personality flash for Host IP. Once the adaptor is set
appropriately, connect an Ethernet cable to the 10/100 Mb management port. In addition
you should also set the Management Port Parameters in the GUI’s Utilities -> Settings
dialog. These should match the settings found in the CLI.
2.3.2 GUI Utility Installation
The Utility comes with sophisticated software Graphical User Interface (GUI). It is highly
intuitive and allows the user to control the EPON and set such things as SLAs, bridging and
VLAN modes, static table entries, and to perform firmware upgrades etc. It is found in the
Utility folder on the CD provided. To install and use the GUI, do the following:
1) Copy the contents of your CD to the PC you will be using as your EPON management
PC.
2) Locate the Utility folder and create a shortcut to the GUI Utility.exe file and place on your
desktop or somewhere suitable.
3) Once you have connected all of the hardware, followed the instructions in the Initial
Power Up section, set the personality flash to suit your management interface method
you can start the GUI. The default MGMT IP is 192.168.1.101 and the Host IP is
192.168.1.100. Please make sure that the IP of your management PC is 192.168.1.100.
Double click on the GUI Utility Icon in the Utility folder or at the shortcut. The GUI should
start and you should see a window similar to the one shown as below figure.
- 24 -