PLANET EPL-1000 - Manual (Page 41)

4.3 OLT Port Management
Allows the user a simple interface to control port parameters such as line speed and flow
control. If Auto Negotiation is enabled, the speed and duplex settings used will be based on
the result of negotiating with the link partner. Default values depend on the personality
settings. The table below describes the Set command. In the current firmware release, flow
control is not auto negotiated. If flow control is enabled the firmware will configure the Phy
to advertise flow control. Note however that pause frames will be transmitted regardless of
the capabilities reported by the link partner.
4.3.1 Configuring Port in Loop
Allows the user to set a loop back, currently the loop back position must be set to MAC.
4.3.2 Manage Flow Ctrl Parameters
Sets the flow control on/off threshold values.
For the Flow Ctrl thresholds: the precision of the values is less than the displayed
percentages. So small changes between the provisioned and actual value may exist
- 41 -