ProSoft Technology PS69-DPM - Manual (Page 119)

PS69-DPM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS DPV1 Master User Manual
ProSoft Technology, Inc. Page 119 of 130
October 1, 2014
6.3.24 MSAL1M_ALARM_CONFIRM
Name Data Type Description
Reserved1 INT
Reserved2 INT
Answer SINT
Failure SINT
Reserved3 INT
SlaveAdr SINT
SlotNum SINT
SeqNum SINT
AlarmType SINT
AlarmSpec SINT
Reserved4 SINT
6.4 Constructing a Bus Cable for PROFIBUS DP
The bus cable for connecting PROFIBUS DP devices must be constructed by the user. A
special PROFIBUS cable (twisted pair) is required here. This standard cable is available
from various manufacturers and is a Belden part number 3079A.
If you plan to construct your own bus cable, the following part numbers are provided for your
convenience.
 PROFIBUS connector: Siemens part number 6ES7972-0BA40-0XA0
 PROFIBUS cable: Belden part number 3079A.
To construct the cable, proceed as follows:
1 Cut the cable to the required length.
2 Prepare the cable ends as shown in the illustration (dimensions in mm):
J PVC Jacket
S Braided shielding
3 Remove the PVC jacket J to the indicated length.