ProSoft Technology PS69-DPM - Manual (Page 64)

Contents PS69-DPM ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS DPV1 Master
Page 64 of 130 ProSoft Technology, Inc.
October 1, 2014
GLOBAL-BITS
Bit Offset Member Name Data Type Signification Meaning if Bit is set
0 Ctrl BOOL CONTROL-ERROR Parameterization error
1 Aclr BOOL AUTO-CLEAR-
ERROR Module stopped communication
with all slaves and reached the
auto-clear-end state.
2 Nexc BOOL NON-EXCHANGE-
ERROR At least one slave has not reached
the data exchange state and no
process data will be exchanged.
3 Fat BOOL FATAL-ERROR Because of major bus error, no
further bus communication is
possible.
4 Eve BOOL EVENT-ERROR The module has detected bus short
circuits. The number of detected
events is contained in the
Bus_error_cnt variable. This bit is
set when the first event was
detected and will remain set.
5 NRdy BOOL HOST-NOT-
READY-
NOTIFICATION
Indicates if the Application program
has set its state to operative or not.
If this bit is set the Application
program is not ready to
communicate
6 Tout BOOL TIMEOUT-ERROR The module has detected an
overstepped timeout supervision
value because of rejected
PROFIBUS telegrams. It is an
indication for bus short circuits
while the master interrupts the
communication. The number of
detected timeouts is available in
the Time_out_cnt variable. This bit
will be set when the first timeout is
detected and will remain set.
7 Reserved1 BOOL Reserved Reserved
ERROR-EVENT Codes for an Err_Rem_adr of 255
Code Indication Source Corrective Action
0 No errors None None.
50 USR_INTF-Task Not Found Master Firmware is invalid. Module must be
updated.
51 No Global Data Master Firmware is invalid. Module must be
updated.
52 FDL-Task Not Found Master Firmware is invalid. Module must be
updated.
53 PLC-Task Not Found Master Firmware is invalid. Module must be
updated.
54 Non Existing Master Parameters Master Execute download of configuration
database again.
55 Faulty Parameter Value in the
Master Parameters Configuration Firmware is invalid. Module must be
updated.