ProSoft Technology PS69-DPM - Manual (Page 88)

Contents PS69-DPM ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS DPV1 Master
Page 88 of 130 ProSoft Technology, Inc.
October 1, 2014
CIP
Status Extended
Status Meaning Cause Help
15 hex 0000 hex Configuration data
size too large
Too much data transferred with
the CIP Message
Check if the overall length of the
requested command send with
the CIP message and the
consistency of all length
parameter within the requested
command is correct.
16 hex 0000 hex Object not supported The requested object does not
exist within the module.
FE hex 0000 hex Message Timeout No answer message was
received.
FF hex 0514 hex General Error
Non specified error
occurred
Call support
FF hex 0517 hex General Error
Unknown command The value in Req.Command is
unknown The value Req.Command must
be initialized
DDLM_Slave_Diag
Failure Significance Error source Help
0 Service could be executed without an error
17 No response from the station DEVICE Check network wiring, check bus
address of slave or baud rate
support
18 Master not into the logical token ring Network in general Check master DP-Address or
highest-station-address of the
Master. Examine bus wiring for
bus short circuits
161 Remote Address in request service out of
range HOST Check parameter in request
message
DDLM_Global_Control
The DDLM_Global_Control command initiates a multicast command on the PROFIBUS
network to all configured slaves. Therefore, this command is always assumed to be
successfully executed and no error will be placed in Cnf.Failure of the answer message.
Failure Significance Error source Help
0 Service was executed without an
error
DDLM_Set_Parameter
Failure Significance Error source Help
0 =
CON_OK Service was executed without an
error
2 =
CON_RR Resource unavailable Slave Slave has no buffer space left for the
requested service
3 =
CON_RS Requested function of Master is not
activated within the Slave Slave Remote SAP is not activated