How to turn on the power of the remote cameras – Panasonic AW-RP60 Remote Camera Controller User Manual
Page 19
19
How to turn on and off the power of the remote cameras
How to turn on the power of the remote
cameras
The power of the remote cameras in the standby state can be turned on
from the unit.
There are the following methods of turning on the power.
z
z
Turning on the power one camera at a time
z
z
Turning on the power of the cameras simultaneously with the turning
on of the unit’s power
z
z
Turning on the power of multiple cameras
¯
Turning on the power of all the cameras
¯
Turning on the power of the selected camera group
Each of these methods is described in turn below.
Turning on the power one camera at a time
1.
Select the remote camera.
By holding down the applicable camera selection button [CAMERA
SELECTION] for about 3 seconds, the name of the remote camera
and the [ON (F2)] and [OFF (F3)] buttons are displayed on the LCD
panel.
z
z
This operation is available when the status screen is being
displayed.
Note
2.
With the camera selection button held down, press the
F2 dial.
CAM1<AW-UE70>
POWER:ON
ON(F2)
OFF(F3)
Turning on the power of the cameras simultaneously
with the turning on of the unit’s power
1.
Press the [MENU] button.
2.
Select the [CAMERA] SYSTEM menu to display the
[AUTO POWER] item.
CAMERA
CAM
POWER
NON
ON
ー
CAM
LOCK
AUTO
POWER
AW-UE70
3.
Turn the F2 dial to select [ON] and press the F2 dial.
The power of remote cameras whose setting in the [CAM1] to
[CAM200] item in the [CONNECT SETTING] SYSTEM menu is set
to either [Serial] or [LAN] turns on when the unit's power is turned
on.
z
z
Depending on the number of cameras connected, it may take
some time before you can operate the unit.
Note
Turning on the power of multiple cameras
1.
Press the [MENU] button.
Press the [MENU] button to light it.
2.
Select the [CAMERA] SYSTEM menu to display the
[CAM POWER] item.
CAMERA
CAM
POWER
NON
ON
ー
CAM
LOCK
AUTO
POWER
AW-UE70
Turning on the power of all the cameras
3.
Turn the F1 dial to select [ALL ON] and press the F1 dial.
Turning on the power of the selected camera group
3.
Turn the F1 dial to select [GRP ON] and press the F1
dial.