Panasonic AW-RP60 Remote Camera Controller - Manual (Page 69)

69
Menu
(continued)
„ „ MANUAL IP SET/USER AUTH
MANUAL IP SET ／ USER AUTH 1/2
CAM SEL
CAM1
192 168 0 10
80 (push)
CAM IP
PORT SAVE
AW-UE70
MANUAL IP SET ／ USER AUTH 2/2
USER NAME
PASSWORD
RETYPE PASSWORD
AW-UE70
NO?
SAVE
___ indicates factory default settings.
Item Setting value Setting details
CAM SEL CAM1
⁞
CAM200
Select the camera control number for which you want to configure settings.
The setting ranges are as follows.
Camera 1 to Camera 200
The network settings for the selected camera control number will appear in the screens that follow.
CAM IP Sets the IP address of the camera.
The setting ranges are as follows.
(IP addresses are assigned in order starting with 192.168.0.10 for CAM1 under factory default
conditions.)
PORT 1
⁞
80
⁞
65535
Sets the port number of the camera.
SAVE (push) Press the F4 dial so the IP address and port number for the camera are set.
z z Settings are not updated until [SAVE] is executed after the settings are changed.
USER NAME Enter the user name that is registered in the camera to be connected.
Turn the F1 dial to select a single character. Press the F1 dial to set each character and enter the
following values. Use the F2 dial to delete a single character.
z z Use [SAVE] to set the entry.
PASSWORD Enter the password that is registered in the camera to be connected.
Turn the F1 dial to select a single character. Press the F1 dial to set each character and enter the
following values. Use the F2 dial to delete a single character.
z z Use [SAVE] to set the entry.
RETYPE PASSWORD Enter the password again.