Panasonic AW-RP60 Remote Camera Controller - Manual (Page 28)

28
Setting the default gateway
1. Press the [MENU] button.
2. Select the [RP IP SET] SYSTEM menu.
3. Operate the menu operation dials to select the
[GATEWAY] item and then press to confirm.
RP IP SET 2/3
GATEWAY
192 168 0 1
61000 61002 61004 61006
61008
PORT
C1
PORT
C3
PORT
C4
PORT
C2
PORT
C5
AW-UE70
z This is set to [192.168.0.1] by default.
4. Use the menu operation dials to set the default gateway
of the unit.
Enter this in 4 blocks of numerals.
If you did not execute [UPLOAD] at the first line of first screen (1/3),
the content you have changed cannot be set.
z z In order for the setting to take effect, the unit must be
restarted. Turn off the unit’s power, and then turn it back on.
Note
Settable addresses
192 168 0 xxx
IP
Block 1
Block 2
Block 3
Block 4
z z For the IP address, you can set values within the following ranges.
Block 1: 1 to 223 Block 2: 0 to 255
Block 3: 0 to 255 Block 4: 1 to 254
However, [127.0.0.1] cannot be set even though it is within the above
ranges.
z z For the subnet mask, you can set values within the following ranges.
Block 1: 0 to 255 Block 2: 0 to 255
Block 3: 0 to 255 Block 4: 0 to 255
However, [0.0.0.0] and [127.0.0.1] cannot be set even though they are
within the above ranges.
Displaying the MAC address
1. Press the [MENU] button.
2. Select the [RP IP SET] SYSTEM menu.
3. Operate the menu operation dials to select the [MAC
ADDRESS] item and then press to confirm.
RP IP SET 3/3
AW-UE70
**-**-**-**-**-**
MAC ADDRESS
z The MAC address can only be displayed. It cannot be changed.
Network settings of the unit (continued)