HP 2000CP 2500CP - Manual (Page 102)

4-16 Service Tests HP DesignJet CP Series Printers
D05. Service Station
The purpose of this test is to verify the operation of the Service Station,
which also includes the Primer Assembly.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE REPLACING
THE SERVICE STATION ASSEMBLY OR THE PRIMER ASSEMBLY. IF
THIS TEST PASSES, CHECK THE TUBES CONNECTING THE
PRIMER ASSEMBLY TO THE SERVICE STATION.
Perform the Service Station test as follows:
1 In the Diagnostics submenu, scroll to “D05 Service Station” and press Enter.
Diagnostics
D05 Service Station
2 While the test is being performed, a row of “***” will be displayed on the
front-panel.
3 If the test passes, the “D0500 OK” message is displayed on the
front-panel.
IF THIS TEST PASSES, DO NOT REPLACE THE SERVICE STATION
ASSEMBLY OR THE PRIMER ASSEMBLY.
4 If the test fails, an error message will be displayed on the front-panel.
The error messages are split into different areas depending on which
component failed.
Primer Assembly Failure
If there is a problem with the Primer Assembly then the following message
will appear:
D “D0501 Fail” - Problem detected in the Primer Assembly.
In this case, Replace the Primer Assembly
' page 8-29.
Service Station Assembly Failure
If there is a problem with the Service Station Assembly then the following
message will appear:
D “D0502 Fail” - Problem in the Hot Initialization of the Service
Station.